Wolf WKED ML-126756 Convection Oven User Manual


 
– 5 –
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT
SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.
Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on
the bottom of the oven and attach the power supply conduit to the bottom of the oven.
Comply with the wiring diagram (located inside the right side panel) when making connections to the
electrical supply lines.
Replace the wiring compartment cover and turn on the power supply.
ELECTRICAL DATA
208-240V 480V
NOMINAL AMPERES PER LINE WIRE
TOTAL
3-PHASE LOADING 3-PHASE LOADING
3-PHASE 1-PHASE
KW KW PER PHASE KW PER PHASE 208V 240V 480V
208V 240V 480V
L1-L2 L2-L3 L1-L3 L1-L2 L2-L3 L1-L3
L1 L2 L3 L1 L2 L3 L1 L2 L3
Single Oven 12.5 4 4 4.5 4 4 4.5 35 33 35 33 29 33 14.4 15.3 15.3 60 52 26
Stacked Oven 25 8 8 9 8 8 9 70 66 70 66 58 66 28.8 30.6 30.6 120 104 52
STACKING FLUE
PL-53463
ASSEMBLING STACKED OVENS
Unpack the ovens and the stack kit. Position
the oven to be used as the bottom oven on
its left side for access to the oven bottom,
taking care not to scratch or damage it.
Attach the four leg assemblies with the 24
bolts and lockwashers (6 per leg).
Place the lower oven (with legs) on the floor
and remove two
7
16" (11 mm) diameter
knockouts on each side of the top cover.
Install two locating studs to the bottom of the
top oven per stacking kit instructions.
Move the oven with legs to the installed
position. Place the upper oven on top of the
lower oven using the locating studs.
Remove the optional rear panel, if provided,
from the TOP oven. Install the Stacking Flue
(Fig. 3) with the four screws provided.
Replace the top oven rear panel, if provided.
Fig. 3