Wolf WKGD ML-126621 Oven User Manual


 
– 6 –
Assembling the Legs to the Oven
The legs must be installed on the bottom of the oven. Gently position the
oven on its side, taking care not to scratch or damage it.
Attach each of the four leg assemblies to the bottom of the oven with the
24 bolts and lockwashers (6 per leg). Carefully raise the oven to its normal
position.
ASSEMBLING THE STAND TO THE OVEN
Attach each of the four leg assemblies to the bottom of the oven with the
24 bolts and lockwashers (6 per leg). Carefully raise the oven to its normal
position. Attach the undershelf to the legs with 8 bolts and lockwashers (2
per leg).
Install the rack guides into the shelf at desired locations (for pan or flat
rack), then attach the rack supports to the top end of the rack guides. Attach
rack supports to the leg assembly by removing one middle bolt and
reattaching back through the end holes in the rack support (Fig. 2).
ASSEMBLING STACKED OVENS (OPTIONAL)
Unpack the ovens and stack kit. Position the oven to be
used as the bottom oven on its back for access to the
oven bottom, taking care not to scratch or damage it. The
gas pipe protrudes beyond the back; provide for this
when the oven is tipped back by resting it on suitable
spacers (2 x 4's, etc.). Attach the four leg assemblies with
the 24 bolts and lockwashers (6 per leg).
Place the lower oven (with legs) on the floor and remove
two
7
16" (1.1 cm) diameter knockouts on each side of the
top cover. Remove vent guard and discard it.
Move the oven with legs to the installed position and
place upper oven on top of lower oven using the locating
studs.
Install the stacking flue (Fig. 3) with the four screws
provided.
Connect the piping between the top oven and bottom
oven. For all gas supply connections, pipe joint compound
must be resistant to the action of propane gases.
LEVELING
Make sure that the oven racks are level in the final installed position. If the oven is installed on legs,
turn the adjustable feet in or out to level the oven front-to-back and side-to-side. If the oven is installed
on casters, loosen set screws and turn casters in or out to level the oven front-to-back and side-to-side.
Retighten set screws after leveling.
MANUAL GAS VALVE (ALL MODELS)
The manual gas valve, located behind the small door in the lower front panel, should remain off until
all electrical and gas connections are made and the ovens are ready to be used.
BACK
FRONT
PL-53274
Fig. 2
Fig. 3
STACKING FLUE
PL-53564