Filter
Top Products
14
WOLF PRO VENTILATION HOOD USE & CARE
Grease Cup SIDE VIEW
Filter
Spring
Recessed controls Filter reinstallation—27" (686) deep
wall hood shown
RECESSED CONTROLS
Controls for Pro ventilation hoods and hood
liners are recessed under the front edge of the
h
ood. Refer to the illustration below.
LIGHT CONTROL
The left rotary switch operates the halogen
lights. There are two settings, HIGH and LOW.
The LOW setting can be used as a night-light.
From the OFF position, turn the switch to the
desired light setting, left for LOW and right for
HIGH light setting.
HEAT LAMP CONTROL
If your hood is equipped with heat lamps, a
center rotary switch will control the lamps.
Each heat lamp may function independently or
both lamps may be activated simultaneously
from the single switch. From the OFF position,
simply turn the switch to the right to activate
the right heat lamp or to the left to activate the
left lamp. When the switch is in the vertical
position, both heat lamps will be activated.
BLOWER CONTROL
The right rotary switch that operates the
blower is variable, allowing infinite control of
the blower speed. Rotate the switch fully
counterclockwise to turn the blower off.
HEAT SENTRY FEATURE
Heat Sentry feature turns the ventilation hood
on when heat is sensed and adjusts the blower
s
peed automatically. The Heat Sentry feature is
activated when the exhaust temperature from
the hood reaches 200˚F (95˚C) and deactivated
w
hen the exhaust temperature decreases to
186˚F (85˚C).
At 200˚F (95˚C) the blower motor will automati-
cally adjust to HIGH speed. When the sensor
cools down to 186˚F (85˚C) it adjusts the blower
back to the setting on the blower control. For
example, if blower motor is in LOW speed and
threshold temperature is reached, the blower
will increase to HIGH speed.
FILTER REMOVAL
To remove the stainless steel filters, push each
filter up at the angle it is placed in and rotate
down. Remove the center filter first. Take out
the grease cups (if applicable) placed on the
bottom edge of the hood coinciding with the
bottom edge of the filters. Gloves should be
worn to provide the proper grip. Reinstall
using the reverse procedure as shown in the
illustration below. Outer filters may need to be
pushed over while the center filter is reinstalled.
IMPORTANT NOTE:
DO NOT operate the
ventilation hood without the filters. This may
cause damage to the blower or other internal
components of the hood.
Blower
Control
Heat Lamps
Control
Halogen
Lights Control