Filter
Top Products
Planning Information
Warming Drawer
MODEL WWD30
Dimensions in parentheses are in
millimeters unless otherwise specified.
10
28
5
/8" (727)
WARMING DRAWER
OPENING WIDTH
5"
(127)
4"
(102)
E
2
3
/8"
(60)
27
3
/16"
(691)
24"min
(610)
27
3
/16"
(691)
NOTE: Unless you are using cabinets deeper than 24" (610), it is recommended that the
electrical supply for the oven be placed in an adjacent cabinet within reach of the conduit.
2"(51) x 2"(51)
ANTI-TIP BLOCK
9
1
/8" (232)
23
7
/8"min (606)
24"min
(610)
9
1
/8" (232)
23
7
/8"min (606)
ANTI-TIP BLOCK APPLICATIONPLATFORM APPLICATION
7
/8" (22)
PLATFORM
7
/8"
(22)
28
1
/2" (724)
OVEN OPENING WIDTH
5"
(127)
4"
(102)
E E
ELECTRICAL LOCATION
WITHIN OPENING
APPLIES ONLY TO
CABINETS DEEPER
THAN 24" (610)
1
7
/16"
min (37)
20
1
/8"min
(511)
18
11
/16"
(475)
1
7
/16"
min (37)
20
1
/8"min
(511)
18
11
/16"
(475)
27
1
/2" (699)
MICROWAVE
OPENING WIDTH
5"
(127)
4"
(102)
E
33" (838)
RECOMMENDED CABINET WIDTH
30"min (762)
Specifications for a warming drawer with E Series stainless steel drawer front installed with a 30" (762) E Series
single oven and convection microwave with 30" (762) E Series trim.
COMBINATION INSTALLATION
The Wolf warming drawer with E Series stainless
steel drawer front may be installed in combina-
tion with a 30" (762) E Series single oven and
convection microwave oven with 30" (762)
E Series trim. Refer to the illustration below for
specifications.
Wolf recommends using a 33" (838) wide
cabinet for this installation. Also, you need a
minimum 24" (610) of usable cabinet depth for
the oven.
IMPORTANT NOTE: Unless you are using
cabinets deeper than 24" (610), it is recom-
mended that the electrical supply for the built-in
oven be placed in an adjacent cabinet within
reach of the conduit.
The base platform for the warming drawer must
be able to support 200 lbs (91 kg), the platform
for the oven must be able to support 250 lbs
(113 kg) and the microwave platform must be
able to support 125 lbs (57 kg).
An anti-tip block or platform must be installed
to prevent the warming drawer from tipping
forward when the drawer is opened. The
warming drawer must be fully enclosed, top
and bottom.
For electrical requirements and additional specifi-
cations, refer to the built-in ovens and microwave
sections of our website, wolfappliance.com.
Also refer to the installation instructions
provided with the warming drawer front and
microwave trim kit for detailed specifications.