Filter
Top Products
Installation Considerations 5
wolfappliance.com/specs
Combination Installations
R
efer to the illustrations showing combination installations
on pages 10–13. Also refer to installation instructions
provided with the other Wolf products.
• The warming drawer may be installed in combination
with a Wolf built-in oven and/or microwave oven.
Additional clearance between warming drawer and
oven openings may be required. To allow the warming
drawer trim and the oven trim to meet, a
7
/8" (22)
platform may be used to separate the two openings.
This will act as the support platform for the oven and
the anti-tip device for the warming drawer. An anti-tip
block may be installed at the rear of the cabinet in
place of the platform. If the warming drawer is installed
above an oven, a
7
/8" (22) platform is required to allow
for clearance of overlaps.
• The warming drawer may be installed below a Wolf
cooktop or sealed burner rangetop. Allow enough
room for gas and electrical connections for the
cooktop.
• The warming drawer may be installed next to or above
another Wolf warming drawer.
• Model WWD30O may be installed below a Wolf
outdoor grill.
Electrical Requirements
Power Supply 120 V AC, 50/60 Hz
Circuit Breaker 15 or 20 amp
Receptacle 3-prong grounding-type
Electrical Requirements
T
he electrical supply should be located as shown in the
illustration for your specific installation on the following
pages. A separate circuit, servicing only this appliance is
required.
IMPORTANT NOTE: You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
If two warming drawers are installed side by side, they can
operate from the same electrical outlet. A 30 amp circuit
breaker is required for this installation.
IMPORTANT NOTE: When installed outdoors, a ground
fault circuit interrupter (GFCI) is required to reduce the risk
of electrical shock.