Filter
Top Products
13
1 Place the appliance on a flat, stable, level
surface where it cannot fall.
2 Place the Mixing Bowl on the Motor Housing
with the handle at a 90 degree angle (see
Figures 6 & 7). Rotate the Mixing Bowl
clockwise as far as possible until you hear it
click into place.
3 Slide the selected disc over the Accessory
Shaft and ensure that the white center ring
on the Accessory Disc is flush with the
Accessory Shaft (see Figure 13)
4 Place the Lid on the Mixing Bowl as show in
Figure 8 and rotate the Lid clockwise as far
as possible. The Lid’s protruding lip must be
slid over the Mixing Bowl’s handle. (See
Figure 9).
5 Pull the Power Cord out of the storage
space at the rear of the Motor Housing.
6 Insert the plug into the wall outlet and turn
the power switch on the side of the Motor
Housing to the ON position
If after plugging the cord in, all indicator
lights are flashing, the Mixing Bowl and/or
the Lid is not placed correctly on the Motor
Housing. For safety reasons it is not possible
to switch on the appliance in Food
Processor Mode UNLESS both bowl and Lid
are properly assembled. Check the position
of the bowl and the Lid and ensure that it
matches Figures 7 & 9. When the Mixing
Bowl and the Lid are fitted correctly, only
the Standby Indicator Light flashes. Only
then can the appliance be operated.
7 Press the I button for continuous low speed.
The Standby Indicator Light will dim and the
blue indicator light will illuminate.
Figure 13
14
8 Add ingredients during use via the Food Chute in the Lid. Use the
Food Pusher to push solid ingredients downwards through the filling
opening. Do not push too hard, slow steady pressure is all that is
needed. Too much pressure could damage the unit.
• Your electronically-controlled motor comes equipped with
an automatic overload protection system which serves
two functions:
1) Time Protection: After two minutes of continuous operation,
the motor will shut off. Fifteen seconds before switching off, the
Standby Indicator Light will begin to flash. This prevents the
motor from overheating during use; and
2) Overload Protection: In the event of an electrical overload,
the motor will automatically shut off. Simply unplug the unit
from the outlet. Wait at least 15 seconds before using again.
• To avoid personal injury or damage to the appliance, never
insert a hand or another object into the Mixing Bowl while the
appliance is operating.
• Always use the Food Pusher to push ingredients. Never use
your fingers, a fork or another object to push ingredients.
9 You can turn the motor off by pressing the Selected Speed button
or if using the P(ulse) button, simply remove your finger from the
button. Switch the power off by pressing the power switch, located
on the right side of the Motor Housing and unplug from the wall
outlet.
10 Remove the Mixing Bowl by rotating counter clockwise and
lifting straight up. Remove the Processing Blade with the Accessory
Shaft from the bowl before emptying. Remove the Cutting Disc from
the Spindle by grasping from the white center ring and lifting
straight up.
Using Your Food Processor
with Slicing or Shredding Disc
HSN_3n1BlenderManual 6/25/10 11:06 AM Page 13