Filter
Top Products
9 10
Helpful Hints
• The hand blender can be used in hot liquids. Always use care when
using in hot liquids. To avoid splashing when using the hand blender
in a saucepan, insert the hand blender into the pan first, set the
speed dial to “1”, and then press the Pulse Button. Slowly increase
the speed to your desired setting. Caution: Do not tilt or lift the
Immersion Blender out of the pan while the motor is running, as a
serious burn or injury can occur from food splatter.
• To puree foods, a certain amount of liquid is needed.
Add cooking liquid, broth, juice, milk, or cream, until desired
consistency is reached.
• For thorough blending, move blade up and down in mixture until smooth.
• You will achieve better mixing results if you use deep, tall containers.
• For easy cleanup, unplug blender and rinse under running water
immediately after using.
• Place liquid ingredients into the beaker first unless recipe specifically
states otherwise.
• Before turning the appliance on, immerse the hand blender attachment
into the prepared ingredients, thus ensuring they will not spill over.
• For greater efficiency, move the appliance in small outward spiraling
circles while mixing, without touching the bottom of the beaker with
the hand blender attachment.
• The hand blender attachment cannot blend hard or fibrous ingre-
dients unless they are in less than 1/2" pieces, soft ones into 1/2 - 1"
pieces.
• Some foods require a small amount of liquid to allow them to move
freely around the blades. Soft or wetter foods require less liquid,
while dry ingredients require more liquid. Add the liquid a little at a
time until the mix gains the required consistency.
• When using the hand blender, ensure the blades are covered to avoid
splashing.
Assembly and Use
of Food Chopper Attachments
1 Ensure the Motor Base is unplugged.
2 Assemble Chopper Bowl by first placing
the Chopping Blade onto the Blade Shaft
in the Chopper Bowl. Then place food in
bowl. For best results, solid foods should
be no larger than 1/2" cubes.
3 Attach the Motor Base onto the Chopper
Lid by pressing down until you hear a click.
4 Attach Motor Base to top of Bowl Cover
by turning clockwise.
5 Plug into 120-volt 60 Hz AC only outlet.
6 Attach the assembled Motor Base with Lid
to the Chopping Bowl Cover as follows:
Line up the tab on the Cover with the
groove on the Chopper Bowl (see figure 1).
Insert cover tab into groove of Bowl and
turn clockwise until it locks in place (see
figure 2).
7 Set the speed selector to 5. Always ensure
your hand is placed firmly on the Bowl
Cover. Use a pulse action when chopping
by pressing and releasing the Pulse Button
until desired consistency.
8 Do not operate the motor continuously for
more than 15 seconds when using chopper
attachment, otherwise food will be too
finely chopped.
9 When you are finished, simply release the
Pulse Button and unplug the Motor Base.
To remove the lid, turn the Motor Base
counter clockwise and lift straight up.
10 Assembly of Nonskid Base/Cover:
The nonskid base also serves as a cover
for your chopping bowls and beaker.
Simply remove the nonskid base from the
bottom of the container and snap into
place on top for storage.
figure 1
figure 2
2020ImmBlderManual 2/19/10 4:28 PM Page 9