Filter
Top Products
Helpful Hints
• Use the flat beater for a variety of mixtures, including cakes, frostings,
biscuits, breads, pastry and cookies.
• Use the wire whisk to incorporate air into mixtures, such as egg whites,
boiled frostings, mayonnaise and sponge cakes.
•Use the dough hook for mixing and kneading bread and other
yeast doughs.
•Never scrape down sides of bowl while mixer in in operation.
If scraping is necessary, first turn the mixer OFF.
• When mixing dry ingredients, always start off at the lowest speed to
avoid splattering.
• When making meringues, the mixer bowl and wire whisk must be very
clean and dry.
• When making whipped creams, first chill the bowl and the whisk.
• Do not overknead dough. Overkneading will prevent the dough
from rising.
• If adding dry ingredients through splash guard, first measure ingredients
onto a piece of parchment paper, then form a cone with the paper
to add ingredients through opening.
Care and Cleaning
1 Make sure speed selector dial is turned to OFF and mixer is unplugged.
2 Raise mixer head to up locked position.
3 Remove bowl, splash guard and attachments.
4 Bowls, flat beater, dough hook, whisk, and splash guard should be
washed in hot, soapy water. Dry all parts thoroughly before storing.
5 Wipe head and base of mixer with a damp cloth.
7 8
Overload Reset Button
Your stand mixer is equipped with an Overload Reset Button. If the mixer
is overloaded, the Overload Reset Button will automatically pop out and
the stand mixer will shut off. If this happens, turn speed control dial to off.
Wait a few minutes, lift mixer head to upright position to locate black reset
button, and then push in the reset button. Lower mixer head to continue
operation as before.
Using Accessory Attachments
A number of OPTIONAL accessory attachments are available for use with
your stand mixer, including a meat grinder, pasta maker and slicer/shredder.
See the following general instructions for assembling and removing these.
ASSEMBLING OPTIONAL FRONT POWER HUB ATTACHMENTS
1 Ensure stand mixer is turned off and the unit
is unplugged.
2 Press down hub release underneath mixer head
and remove hub cover by pulling outward.
3 Insert the shaft of the accessory into hub
ensuring that the accessory stands vertical in the
hub. When properly inserted, the pin from the
hub release will line up with the hole in the
accessory, holding accessory firmly in place. If
the accessory does not stand vertically in the
hub, and does rest against the hub, pull the
accessory out slightly and turn to the left or right
until pin lines up with hole.
REMOVING FRONT POWER HUB ATTACHMENTS
1 Turn stand mixer off and unplug from outlet.
2 Pull the attachment out from the stand mixer while pressing down
on the hub release.
3 Affix hub cover to the front of stand mixer while holding down hub
release. When aligned properly, let go of hub release.
NOTE: The hub located at the top rear of your stand mixer is for the
optional 40-ounce glass-jar blender attachment. Twist counter-clockwise
to remove rear cover and clockwise to attach.