Filter
Top Products
16
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON-OFF push
button
The ON-OFF indicator light will come on.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the recommended
quantity given in the Washing programmes
chart.
Important!
If the half load option is selected
remember to reduce the quantity of
detergent.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the
programme without DELAY
START
Press the push button corresponding to the
required programme: the indicator light
corresponding to the programme illuminates
and the phase indicator lights for that
programme start flashing.
Select, if required, the HALF LOAD option.
The start of the programme will occur after
about 6 seconds from the last pressure of a
push button (programme or HALF LOAD push
button), in this time it is possible to change
programme simply pressing the push button
of another programme.
Once the programme has started the phase
indicator lights will turn off except for the
phase under way.
It is possible to interrupt the programme
by:
● opening the door
● pressing the ON-OFF (in this case all the
indicator lights turn off)
Close the door again or press the ON-OFF,
the programme will start from the point in
which it was interrupted.
8b. Setting and starting the
programme with DELAY
START
The setting of the delay start occurs
before selecting the programme.
Press the DELAY START push button and
selected the desired time (3, 6 or 9 hours)
until the indicator light corresponding to the
chosen hours flashes.
Press the push button corresponding to the
required programme: the indicator light
corresponding to the programme illuminates
and the phase indicator lights for that
programme start flashing.
The start of the countdown will occur after
about 6 seconds from the last pressure of a
push button (programme or HALF LOAD push
button).
The countdown will decrease with step of 3
hours and you are informed of this by the
indicator lights of the hours.
Operating sequence