Filter
Top Products
12
In case that plates are loaded in the
upper basket:
load them starting from the rear positions of the
basket; tilting them slightly forwards and
avoiding the front positions near the door.
Adjusting the height of the upper
basket
If washing very large plates (over 27 cm and up to 32
cm in diameter) you can load them in the lower basket
after moving the upper basket to the higher position.
To move to the higher position proceed as follows:
1. Pull out the basket until it stops.
2. Carefully lift both sides upwards until the
mechanism is engaged and the basket is stable.
When the top basket is in the higher
position it will only take plates up to 20 cm
in diameter and you will not be able to use
the raised cup racks.
To lower the basket to the original position
proceed as follows:
1. Pull out the basket until it stops.
2. Carefully lift both sides upwards and the allow the
mechanism to drop back slowly, keeping hold of it.
Never lift or lower the basket on one side
only.
After loading your machine always close
the door, as an open door can be a hazard.
RC04
US71