Filter
Top Products
7
ELECTRICAL CONNECTIONS
WARNING: This appliance must be earthed. The
manufacturer declines any liability should this
safety measure not be observed.
Before you use your appliance, check that the voltage
shown on the data plate inside the cabinet conforms
with your mains supply.
The mains lead of the appliance is fitted with a non-
rewireable moulded-on 13A plug a containing a 13
amp fuse. In the event of the fuse requiring
replacement, the fuse cover/carrier should be
removed, using a small screw driver to lever it out.
The old fuse should be replaced by a 13 amp ASTA
approved BS1362 fuse and the fuse cover/carrier
must be refitted before the plug is used again.
If the plug fitted is not suitable for your socket outlet, it
must be cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug. The cut off
plug should then be disposed of to prevent the hazard
of shocks in case it should be plugged into a 13 Amp
socket in another part of your home.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
The wire coloured green and yellow (earth) must be
connected to the terminal in the plug which is marked
with the letter «E» or the earth symbol or coloured
green and yellow.
The wire coloured blue (neutral) must be connected
to the terminal in the plug which is marked with the
letter «N» or coloured black.
The wire coloured brown (live) must be connected to
the terminal in the plug which is marked with the letter
«L» or coloured red.
Upon completion, there must be no cut, loose or stray
stands of wire present and the cord clamp must be
secure over the outer sheath.
If the supply cable of this appliance is damaged, it
must be replaced by special cord (spare part ref.
567364415) that can be obtained from your local
Zanussi Service Centre.
Fig. 4