Filter
Top Products
Problem Possible cause Possible solution
The filter in the water inlet hose is clog-
ged.
Clean the filter.
The water inlet hose has a kink or a
bend.
Make sure that the position of the hose is
correct.
The appliance does not drain
the water.
The sink spigot is clogged. Clean the sink spigot.
The water drain hose has a kink or a
bend.
Make sure that the position of the hose is
correct.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Service.
If other alarm codes show, contact the Service.
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The filters are clogged. Clean the filters.
The filters are not correctly assembled
and installed.
Make sure that the filters are correctly as-
sembled and installed.
The spray arms are clogged. Remove remaining soil with a thin pointed
object.
The programme was not applicable for
the type of load and soil.
Make sure that the programme is applica-
ble for the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all items.
Make sure that the position of the items in
the baskets is correct and that the water
can easily wash all items.
The spray arms could not turn freely. Make sure that the position of the items in
the baskets is correct and does not cause
the blockage of the spray arms.
The quantity of detergent was not suffi-
cient.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
There was no detergent in the detergent
dispenser.
Make sure that you add detergent in the
dispenser before you start a programme.
Limescale particles on the
dishes.
The salt container is empty. Make sure that there is dishwasher salt in
the salt container.
The set level of the water softener is in-
correct.
Make sure that the set level of the water
softener agrees with the water hardness in
your area.
The cap of the salt container is loose. Tighten the cap.
23