Zanussi ZBC 848 Oven User Manual


 
17
Something not working
SYMPTOM
The oven does not come on
The oven light does not come on
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and
the oven cavity.
The timer does not work
The oven fan is noisy
SOLUTION
Check the oven is in manual operation and that both
a cooking function and temperature have been selected
Check the fuse and ensure the socket switch or the
switch from the mains supply to the oven are ON
Select a temperature with the thermostat control knob
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
The temperature may need adjusting
Refer to the cooking function sections and to any
cooking chart provided
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed
Check the instructions for the timer
Check the grease filter is correctly fitted.
Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
If the appliance is not working correctly, please carry out the following checks, before contacting your local Zanussi
Service Force Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
In the event of your appliance requiring service, or if
you wish to purchase spare parts, please contact your
local Zanussi Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to the
Service Force Centre covering your post code area. The
addresses are listed on the following pages.
Before calling out an engineer, please ensure you have
read the details under the heading “Something Not
Working.”
When you contact the Service Force Centre you will
need to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of the fault
4. The model and serial number of the appliance (found
on the rating plate)
5. The purchase date
Service and Spare Parts
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.