Filter
Top Products
15
Something Not Working
SYMPTOM
The hob hotplate does not heat up.
The plate is not giving satisfactory results
The oven does not come on
The oven temperature light does not come on
The oven light does not come on
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and the
oven cavity.
The oven fan is noisy
SOLUTION
Check that the unit is plugged in and the electrical
supply is switched on
Check that the RCCB has not tripped (if fitted)
Check the mains fuse has not blown
Check the correct control knob has been turned.
Check the plate is clean and dry
Check the cooking pan is the correct size for the plate.
Check the cooking pan has a flat bottom
Check the setting is correct for the type of cooking.
Check that both a cooking function and temperature
have been selected.
Check that the socket switch or the switch from the
mains supply to the cooker are ON.
Select a temperature with the thermostat control knob
Select a function with the oven function control knob.
Select a function with the oven function control knob
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
The temperature may need adjusting
Refer to the contents of this booklet, especially to
the chapter “Using the Oven”.
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
If the appliance is not working correctly, please carry out the following checks, before contacting your local Zanussi
Service Force Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
If after all these checks, the cooker still does not work, contact your local Zanussi Service Force Centre.