Filter
Top Products
18
115
780
420
A
B
C
D
E
Installation
Fig. 1
1. Positioning the Appliance
(Fig. 1)
Note A:
The appliance is designed to be flush fitted with
2mm clearance at each side to allow for it to be pulled
forward for cleaning etc.
Note B:
The hotplate side trims should be flush with the
cabinets and must not be below. Adjustable levelling feet
at the front and rear are provided on the base of the
appliance. Adjustment is obtained by rotating in or out,
the feet at the front or rear of the appliance from the
underside of the appliance, with the drawer removed.
A spirit level should be placed on a cake tray on one of
the shelves to confirm that the appliance is correctly
levelled.
The levelling feet fitted to the appliance will achieve a
height to hotplate trims of 900mm-0 + 20mm.
Note C:
If the appliance is fitted next to a side wall or
cabinets above height of the hotplate trims, then a gap
of 115 mm is required.
Curtains must not be fitted immediately behind the
cooker or within 115 mm of the sides of the cooker.
Note D:
Any wall cabinet or extractor must not be lower
than 780mm above hotplate level.
Note E:
Wall cabinets may be fitted in line with the sides
of the base units, providing that the lower edge of the
wall cabinet is a minimum of 420mm above the worktop.
The appliance must be installed in accordance to the
type X (standard EN 60335-2-6).
Therefore the appliance can not be installed beside
furniture higher than the cooker worktop.
This cooker must only be installed by qualified
personnel, according to the manufacturers instructions
and to the relevant British Standards.
FO 1141
Location of the appliance
This appliance must not be installed in a bed-sitting room
of volume less than 20m³ or in a bathroom, shower room
or garage. It is essential that the appliance is positioned
as stated below (see fig.1) i.e. shelves, wall cabinets
and cooker hoods must be fitted a minimum of 787mm
directly above the top of the hotplate and 400mm above
the hotplate when fitted in line with the outside of the
appliance. If the units are intended to be fitted adjacent
to the appliance but less than 400mm above the hotplate,
then a minimum space of 100mm must be maintained
between the sides of the unit and the appliance (see fig.).
Curtains must not be fitted immediately behind the
appliance or within 150mm of the sides of the hotplate. If
fitted next to or between two base units a minimum space
of 1mm must be left between each unit and the side of
the appliance. The levelling feet fitted to the appliance
will achieve a nominal height to hotplate trims of 900mm
+20mm.
L.P.G. cookers MUST NOT be installed below ground level,
i.e. in a basement, or aboard any boat, yacht or other
vessel.
Positioning the Cooker
Caution:
Some soft or badly fitted floor coverings can be damaged
when the cooker is moved across their surface for
cleaning. It is advisable to ensure that the floor covering
in the area below the cooker is either securely fixed so
as not to ruck up when the cooker is moved or, if
preferred, removed.