Zanussi ZCM 1000X Cooktop User Manual


 
18
LOCATION OF APPLIANCE
This appliance is not for commercial use and must only be installed in domestic premises.
This appliance must not be installed in a bed-sitting room of volume less than 20m
3
or in a bathroom, shower or
garage. This is a type ‘X’ appliance, it is essential that the appliance is positioned as stated below i.e. shelves,
wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top of the hotplate (or
greater for cooker hoods if recommended by manufacturers instructions) and 400mm above the hotplate when
fitted in line with the outside of the appliance. If the units are intended to be fitted adjacent to the appliance but
less than 400mm above the hotplate, then a minimum space of 100mm must be maintained between the sides of
the unit and the appliance. The hotplate must be a minimum of 5mm above the height of adjacent units. Curtains
must not be fitted immediately behind the appliance or within 150mm of the sides of the hotplate. If fitted next to
or between two base units a minimum space of 1mm must be left between each unit and the sides of the
appliance.
Fig 1
INSTALLATION INSTRUCTIONS