Filter
Top Products
28
REAR WALL
165 mm
☞
Fitting the Stability Bracket
(Not supplied)
If the cooker has to be installed with a flexible supply
pipe, it is necessary that a stability device is fitted.
If a stability bracket should be fitted by the installer,
these instructions should be read in conjunction with
the leaflet packed with the stability bracket.
1. Place the cooker in its intended position
and mark the cooker height.
2. Mark 165mm below the cooker height. This
is the position of the stability bracket.
3. Fix a large type of stability bracket (using
two of the provided five fixing holes) to
the rear wall (see the picture below).
4. Pull the cooker towards the rear wall as
shown in the diagram. The stability bracket
should then come into contact with the rear
panel of the cooker (see diagram).
Should the stability bracket currently installed not
allow the cooker to stand correctly, ask the installer
to replace it with the correct type.