Filter
Top Products
Installation
Warning! Refer to "Safety information" chapter.
Technical Data
Dimensions
Height 900 mm
Width 596 mm
Depth 600 mm
Top oven capacity 37 l
Main oven capacity 74 l
Location of the appliance
You can install your freestanding appliance with cabinets
on one or two sides and in the corner.
A
A
B
Minimum distances
Dimension mm
A 2
B 685
Levelling
Use small feet on the bottom of appliance to set same lev-
el of cooker top surface with other surfaces
The anti-tilt protection
Caution! You must install the anti-tilt protection (A
+B). If you do not install it the appliance can tilt.
Before you install anti-tilt protection, adjust the appliance
to the correct height.
The anti-tilt protection has two parts (A+B). You can find
the anti-tilt protection (B) on right or left side of the rear
wall of the appliance (See fig. 1). You must install the an-
ti-tilt protection (A) on the wall. The distance of the hole of
the anti-tilt protection (A) from the floor is about 816 mm.
Make sure you install the anti-tilt protection (A) at the cor-
rect height. Screw it into the solid material or use applica-
ble reinforcement.
Check that the anti-tilt protection projects minimum 20
mm into the hole in the back of the appliance (B) when
you push the appliance (See fig. 2). If the space between
the bench cupboards is greater than the width of the appli-
ance, you must adjust the side measurement to centre the
appliance. Make sure that the surface behind the appli-
ance is smooth.
18