30
BEFORE CLEANING ALWAYS ALLOW
THE COOLING FAN TO COOL THE
APPLIANCE DOWN BEFORE SWITCHING
OFF AT THE ELECTRICITY SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Abrasives must
also be avoided to prevent damaging the stainless
steel or painted finishes.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials, e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur.
Regularly wipe over the control panel, oven doors
and appliance sides using a soft cloth and hot soapy
water. To prevent streaking on stainless steel
models finish with a soft cloth. Any spillage on the
stainless steel finish must be wiped off
immediately.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
CLEANING THE STAINLESS BRUSHED
STEEL CONTROL KNOBS AND
HANDLES (WHERE APPLICABLE)
It is strongly recommended that only hot soapy water
is used for cleaning the control knobs and door
handles
ANY OTHER CLEANING MATERIALS WILL DULL
THE STAINLESS BRUSHED STEEL FINISH.
CLEANING INSIDE THE OVENS
The vitreous enamel oven interiors can be cleaned
using normal oven cleaners or aerosol oven cleaners
with care. Ensure that the manufacturers instructions
are followed and that all parts are well rinsed
afterwards. Aerosol cleaners must not come into
contact with elements or the door seal as this may
cause damage.
CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle can
be washed in the dishwasher.
The grill pan, grill pan grid, meat tin, oven shelves
and wirework runners may be cleaned using a soap
impregnated steel wool pad. Soaking first in hot
soapy water will make cleaning easier.
TO REMOVE THE WIREWORK RUNERS
The wirework runners in both ovens can be removed
for cleaning.
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom and gently pull
towards the centre of the oven.
3. Unhook the runner at the top and remove it from
the cavity.
4. To replace, hook the wirework back into the oven
sides.
Ensure that the wirework runners are firmly
in place before refitting the oven shelves.
CARE AND CLEANING