Zanussi ZDI 6041 Dishwasher User Manual


 
3
Washing programmes
Operating sequence
Programme Type of load and
degree of soil
Starting position
of the programme
selector dial
Required
push button
Recommended
quantity of detergent
wash
prewash
Cycle
description
*
HEAVY SOIL
65°C
NORMAL SOIL
65°C
**
QUICK WASH
65°C
RINSE AND
HOLD
Cold prewash
Main wash up to 65°C
1 cold rinse
1 hot rinse
Drying
Main wash up to 65°C
1 cold rinse
1 hot rinse
Drying
Main wash up to 65°C
1 cold rinse
1 hot rinse
1 cold rinse
Heavy soil.
Crockery, cutlery, pots
and pans
Normal soil.
Crockery and cutlery
Light soil.
Crockery, cutlery and
party crockery
A
B
C
D
On/Off
On/Off
On/Off
On/Off
**
This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you
may re-use them promptly.
*
Testing programme for EN 50242 (see "Hints for Test Centres).
25 g 5 g
30 g /
30 g /
//
Partial load (to be
completed later in the
day).
1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning" - Instruction book part 1).
2. Check that there is rinse aid and salt
(See "Instruction book - part 1")
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4. Ensure that the spray arms can
rotate freely
5. Measure out detergent
Add the required amount of detergent into the dispenser
according to the "Washing programmes" chart.
Close the detergent dispenser lid.
6. Close the dishwasher door
7. Set the programme
Turn the programme selector dial clockwise until the
letter of the programme you wish to select corresponds
with the programme marker on the control panel.
8. Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and the machine
will start.
If you wish to interrupt the washing programme at any
time press this button again.
9. At the end of the washing programme
At the end of the programme the dishwasher will
automatically stop.
The On/Off indicator light remains on until the On/Off
push button is depressed.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off push
button and open the door.
Wait a few minutes before removing the dishes; in this
way they will be cooler and the drying will be improved.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
Important!
Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
steam may escape.