Filter
Top Products
Loading your appliance
Before placing dishes in the machine, remove any scraps of
food, to avoid clogging the filters and consequently reducing
the performance.
Do not load very small items which can fall through the
baskets.
The lower basket
The lower basket is designed to take saucepans, lids, plates,
salad bowls, cutlery etc.
Serving dishes and large lids should be arranged around the
edge of the basket, ensuring that the upper spray arm can
turn freely.
The cutlery basket
Long bladed knives stored in an upright position are a
potential hazard.
Long and/or sharp items of cutlery such as carving knives
must be positioned horizontally in the upper basket.
Take care when loading or unloading sharp items such as
knives.
Cutlery should be placed in the removable cutlery basket with
the handles facing downwards.
If the handles protrude from the bottom of the basket,
obstructing the lower spray arm, load the cutlery with the
handles facing upwards.
Mix spoons with other cutlery to prevent them from sticking
together.
For best results we recommend to use the cutlery grids
provided (if the size and the dimensions of the cutlery allow it).
The cutlery basket is in two parts which can be separated to
give greater loading flexibility. To separate the two parts, slide
them horizontally in opposite directions and pull them apart. To
reassemble, reverse the procedure.
The upper basket
The upper basket is designed for plates (dessert plates,
saucers, dinner plates of up to 25 cm in diameter), salad
bowls, cups and glasses.
Arrange items so that water can reach all surfaces.
Light items (plastic bowls etc.) should be loaded in the upper
basket and arranged so they do not move.
In case that plates are loaded in the upper
basket:
load them starting from the rear positions of the basket, tilting
them forwards and avoiding the front positions near the door.
Before closing the door, ensure that the spray arms can
rotate freely.
Adjusting the height of the upper
basket
If washing very large plates (over 27 cm and up to 32 cm in
diameter) you can load them in the lower basket after moving
the upper basket to the higher position.
To move to the higher position proceed as follows:
1. Move the front runner
stops (A) of the upper
basket outwards and
slide the basket out.
2. Refit the basket in the
higher position and
replace the stops (A) in
their original position.
When the top basket is in the higher position it will only
take plates up to 20 cm in diameter and you will not be
able to use the raised cup racks.
Attention!
After loading your machine always close the door, as an
open door can be a hazard.
4
Using your appliance
UI48
UI21
UI62
UI63
US64
A
RC01
US71