Filter
Top Products
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off button
The On/Off indicator light will come on.
5. Setting and starting the programme
Press the button corresponding to the required programme
(see "Washing programmes" chart).
The indicator light corresponding to the programme and
the phase indicator lights foreseen for that programme will
start blinking.
After about 3 seconds from the last pressure of a button
the programme starts automatically.
Once the programme has started the phase indicator lights
will turn off except for the phase under way.
If you want to set the delay start of a
washing programme
Set the delay start before selecting a washing
programme.
Press the delay start button until the indicator light
corresponding to the chosen hours flashes (3h, 6h or 9h)
Press the button corresponding to the required programme
(see "Washing programmes" chart).
After about 3 seconds from the last pressure of a button
the countdown starts automatically.
The countdown will decrease with steps of 3 hours.
The opening of the door will not modify or interrupt the
countdown.
Once the delay start has elapsed the programme will
start automatically.
Note: it is possible to select a washing programme and
the delay start also with the door slightly opened.
In this case the start of the programme or of the
countdown will occur after about 3 seconds from the
closure of the door.
6. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point at which it was interrupted.
b) Press the On/Off button (in this case all the indicator
lights turn off). Press the On/Off push button again; the
programme will start from the point at which it was
interrupted.
To cancel a washing programme in
progress
To cancel a washing programme in progress, press
simultaneously the function buttons 2 and 3 until all the
indicator lights will turn off (except for the On/Off indicator
light and eventually the rinse aid and salt indicator lights)
indicating that the running programme has been cancelled.
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
7. Cancelling the "delay start" in
progress
It is possible to cancel a countdown in progress or before
it starts, simply pressing the delay start button until the
indicator lights corresponding to the delay start hours (3h,
6h or 9h) turn off.
In this case the selected washing programme will start
automatically after a 3 seconds.
8 . End of the washing programme
The dishwasher will automatically stop and the end of
programme phase indicator light will illuminate.
The indicator light of the programme just ended will
remain on.
Switch off the dishwasher by pressing the On/Off button,
the On/Off indicator light turns off.
Open the dishwasher door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
be cooler and the drying will be improved.
9. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme
15