Filter
Top Products
Using the detergent
Caution!
Use only detergents for dishwashers.
Do not use more than the correct quantity of deter-
gent. Refer to the instructions on the detergent
packaging.
1 2
A
3
Put the detergent or the
tablet in compartment (A
A
).
A
B
If the programme has a
prewash phase, put a
small quantity of detergent
in compartment (B
B
).
4
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on the
dishes.
We recommend that you use detergent tablets with long
programmes.
C
Combi detergent tablets
These tablets contain detergent, rinse aid and other added
agents. Be sure that these tablets are applicable to the wa-
ter hardness in your area. Refer to the instructions on the
packaging of the products.
When you use tablets, that contain salt and rinse aid, do
not fill the salt container and the rinse aid dispenser. The
rinse aid indicator always comes on if the rinse aid dis-
penser is empty.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse ai
d and dishwasher
salt, do these steps:
1. Press the on/off button to activate the appliance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the shortest programme with a rinsing phase,
without detergent and without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• All the programme indicators are off.
• The end indicator flashes.
If the control panel shows other conditions, press and
hold the programme button until the appliance is in set-
ting mode.
Starting a programme
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press continuously the programme button until the
indicator of the programme you want to set comes on.
4. Close the appliance door. The programme starts.
20