Filter
Top Products
D
A
5
Put filter (A
A
) to its initial
position. Make sure that it
assembles correctly under
the two guides (D
D
).
6
Assemble filters (B
B
) and
(C
C
). Put them into position
in filter (A
A
). Turn the han-
dle clockwise until it
locks.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove remain-
ing parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Troubleshooting
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
With some problems, some indicators flash continuously
and/or intermittently at the same time to show
an alarm
code.
Alarm code Problem
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 2 times intermittently.
The appliance does not drain the water.
Warning!
Deactivate the appliance before you make
the checks.
Problem Possible cause Possible solution
The programme does not
start.
The mains plug is not connected in the
mains socket.
Connect the mains plug.
The appliance door is open. Close the appliance door.
The fuse in the fuse box is damaged. Replace the fuse.
The appliance does not fill
with water.
The water tap is closed. Open the water tap.
The water pressure is too low. Contact your local water authority.
The water tap is clogged or there is lime-
scale on it.
Clean the water tap.
22