Filter
Top Products
2. Release function buttons B and C to cancel the wash-
ing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent before you set
a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
Setting and starting a washing programme with
delay start
1. Press the on/off button.
2. Set a washing programme.
– The programme indicator light comes on.
3. Press the delay start button until the indicator light
with the correct number of hours starts to flash (3, 6,
or 9 hours).
4. Close the door.
– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 3 hours.
When the countdown is completed, the washing
programme starts automatically.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close the
door again, the countdown continues from the point of
interruption.
Cancelling a delay start:
1. Press and hold function buttons B and C until all the
programme lights come on.
– When you cancel a delay start, you also cancel the
washing programme.
2. Set a new washing programme.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signals for the end of the programme op-
erate.
1. Open the door.
– The end indicator light comes on.
– The programme indicator light stays on.
2. Press the on/off button.
3. For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the appli-
ance. Stainless steel becomes cool more quickly than
the dishes.
Care and cleaning
Warning! Switch the appliance off before you clean
the filters.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1 2
Fully clean the filters A, B
and C below running wa-
ter.
12