Filter
Top Products
Warning! To discard the appliance, follow the
procedure:
• Pull the mains plug out of the socket.
• Cut off the mains cable and mains plug and discard
them.
• Discard the door catch. This prevents the children to
close themselves inside the appliance and endanger
their lives.
Installation
Warning! Make sure that mains plug is
disconnected from the mains socket during
installation.
Important! Obey the instructions in the enclosed template
to:
• Build-in the appliance.
• Install the furniture panel.
• Connect to the water supply and drain.
Install the appliance under a counter (kitchen worktop or
sink).
If a repair is necessary, the appliance must be easily ac-
cessible for the engineer.
Put the appliance adjacent to a water tap and a drain.
For the venting of the dishwasher only water fill, water
drain and power supply cable openings are necessary.
The dishwasher has adjustable feet to allow the adjust-
ment of the height.
Make sure that the water inlet hose, the drain hose and
the supply cable are not kinked or squashed, when you
insert the machine.
Attaching the appliance to the adjacent units
Make sure that the counter below which you attach the
appliance is a safe structure (adjacent kitchen units, cab-
inets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal the
door correctly. If the level of the appliance is correct, the
door does not catch on the sides of the cabinet. If the door
does not close correctly, loosen or tighten the adjustable
feet until the appliance is level.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°) or cold water
supply.
If the hot water comes from alternative sources of energy
that are more environmentally friendly (e.g. solar or pho-
tovoltaic panels and aeolian), use a hot water supply to
decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4”.
Caution! Do not use connection hoses from an old
appliance.
The water pressure must be in the limits (refer to the
chapter 'Technical data'). Make sure that the local water
authority gives you the average mains pressure in your
area.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entangled.
Turn the inlet hose to the left or the right to suit the in-
stallation. Fit the locknut correctly to prevent water leaks.
Caution! Do not connect the appliance to new pipes
or pipes that are not used for a long time. Let the
water run for some minutes, then connect the inlet hose.
Water inlet hose with safety valve
The water inlet hose is a double-walled and has an inner
mains cable and a safety valve. The water inlet hose is
under pressure only while the water is running. If there is
a leak in the water inlet hose, the safety valve interrupts
the running water.
Warning! Danger-
ous voltage
Be careful when you connect the water inlet hose:
16