Zanussi ZDT 312 Dishwasher User Manual


 
The wash results are not satisfactory
The dishes are not clean The wrong washing programme has been selected.
The dishes are arranged in such a way as to stop
water reaching all parts of the surface. The baskets
must not be overloaded.
The spray arms do not rotate freely due to incorrect
arrangement of the load.
The filters in the base of the washing compartment
are dirty or incorrectly positioned.
Too little or no detergent has been used.
Where there are limescales deposits on the dishes;
the salt container is empty or the incorrect level of
the water softener has been set.
The drain hose connection is not correct.
The salt container cap is not properly closed.
The dishes are wet and dull Rinse aid was not used.
The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating on
glasses and dishes
Decrease rinse aid dosing.
Water drops have dries onto glasses and dishes Increase rinse aid dosing.
The detergent may be the cause. Contact the de-
tergent manufacturer’s consumer care line.
If after all these checks, the problem persists,
contact your local Service Force Centre.
Contact your local Service Force Centre, quot-
ing the model (Mod.), product number (PNC)
and serial number (S.N.). This information can
be found on the rating plate located on the side
of the dishwasher door.. So that you always
have these numbers at hand, we recommend
you to make a note of them here:
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Consumption values
The consumption values are intended as a
guide and depends on the pressure and the
21