Filter
Top Products
15
Failure to align the top edge of the decor panel
with the template will prevent the visor from
opening when installed.
3. Before drilling, use a tape measure to check the
distances of the screw holes (as given on the
template). The template may have altered due
to dampness after manufacture.
4. Use the 6 x 15mm (1/2 ins) round headed screws
provided to attach the decor panel to the hood
visor.
To Refit the Hood with Decor Panel
Attached
1. Insert the upper visor guides into the upper track
in the front of the casing.
2. Hinge down the bottom edge of the visor and
insert the lower guides into the track in the bottom
of the casing.
3. Push the visor in until an audible click is heard.
4. The visor can now be opened and closed in its
normal function.
Adjustment
If a heavy door is fitted or if the visor will not
stay closed it may be necessary to make an
adjustment to the closing mechanism of the
visor.
Insert a small flat bladed screw driver through
the hole (the friction assembly) on either side
of the casing indicated by the letter “V” and
turn clockwise to apply pressure on the guide.
Both friction assemblies should be adjusted
by the same amount to ensure the visor opens
smoothly.
Care should be taken when removing the visor
with the decor panel for cleaning or servicing,
as the visor is now extremely heavy and
should it be dropped, it could damage the
appliance beneath and adjoining work
surfaces.