Filter
Top Products
INSTALLING THE COOKER HOOD
• Assemble the two halves of the
recirculation air extension tube item 14.
• Push fit the assembled recirculation air
extension tube item 14 onto the air outlet.
• Push fit the air outlet connector item 15
onto the recirculated air outlet extension
tube item 14.
• Insert the connection extension pieces
item 14.1 into either end item 15.
• Make sure that the assembly is correctly
aligned both horizontally and vertically. If
this is not the case, adjust the position of
item 14.1 by reversing them or by cutting
the recirclated air extension tube item 14
along one of the thinner section channels,
which denote the prefixed lengths, then
reassemble as discribed above.
• The air outlet grilles item 8a - 8b must not
be fitted until the lower chimney item 2.2
has been installed.
• Ensure the activated charcoal filter has
been fitted.
Electrical Connection
Connect the hood to the mains supply as
instructed on Page 10
Fitting the Upper Chimney
• Slightly widen the two sides of the upper
chimney and hook them behind the
brackets item 7.2.1 ensuring they are
correctly seated.
• Secure the sides to the brackets using the
4 screws item 12c (2.9 x 9.5mm)
supplied.
Fitting the Lower Chimney
• Slightly widen the two sides of the lower
chimney and hook them between the
upper chimney and the wall, ensuring they
are correctly seated.
• Fix the lower chimney to the hood body
using 2 screws item 12c (2.9 x 9.5mm)
supplied.
• When in the recirculation mode, fit the
grilles item 8a - 8b in the lower chimney
ensuring the arrows on the grilles point
upwards and forwards. Also ensure that
they are correctly fitted in the extension
pieces item 14.1.
Page 15
14
14.115
8a
8b
12c
8a
2.1
2.2
2
8b
7.2.1
12c