Filter
Top Products
16
What to do if …
Problem Possible cause Remedy
The cooking zones will not switch
on or are not functioning
More than 10 seconds have passed
since the appliance was switched
on
Switch the appliance on again.
The child safety device is switched
on
l
Deactivate the child safety device
(See the section “Child safety de-
vice”)
Several sensor fields were touched
at the same time
Only touch one sensor field
The sensor fields are partly covered
by a damp cloth or with liquid
Remove the cloth or the liquid.
Switch the appliance on again.
Safety cut-out has been triggered Switch the appliance on again
The lock is switched on
l Switch off the lock (See the section
“Locking/unlocking the control
panel”)
The residual heat indicator is not
displaying anything
The cooking zone was only on for a
short time and is therefore not hot
If the cooking zone is supposed to
be hot, call your local Service Force
Centre.
The automatic warm up function is
not switching itself on
There is still residual heat on the
cooking zone h
Let the cooking zone cool down
The highest heat setting is set Ç The highest heat setting has the
same power as the automatic warm
up function
The heat setting was set using the
sensor field
1.Switching off the cooking zone
1.Set the cooking zone using the
sensor field
Acoustic signal sounds and appli-
ance switches itself on and then off
again; after 5 seconds another
acoustic signal sounds
The On/Off sensor field has been
covered up, e.g. by a cloth
Do not place any objects on the
control panel
_ is lit Overheating protection for the
cooking zone has been triggered
Switch off the cooking zone.
Switch the cooking zone on again
e and number are displayed Electronics fault Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house’s
wiring system)
If after switching on again,
e is dis-
played again, call the customer
service department