Filter
Top Products
13
When the ice melts, the water flows through the
defrost water outlet through the back into the
evaporator tray which sits on the top of the
compressor and evaporates due to its warmth.
Check and clean the defrost water outlet
regularly - a label inside the appliance
warns you for this. If it is blocked the water
gathered can cause damage to the insulation of
the appliance.
Clean the defrost water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
Extra care should be taken when putting wrapped
foods, especially in paper, in the appliance.
Blockages to the defrost water outlet often occurs
when wrapped foods are placed in the back of the
refrigerator, and the wrapping contacts the back plate
of the fridge and sticks to it.
In case of increased demand e. g. during
heatwawes, the refrigerator temporarily happens
to operate constantly - during this the automatic
defrosting does not work.
Remaining small ice and frost stains on back plate of
the refrigerator after the defrosting period is normal.
Defrosting of the freezer is automatic in this model.
Important
A temperature rise of the frozen food packs during
defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as this could damage the appliance
beyond repair.
)
To Change the Light Bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the cover (1), press the
rear hook (2) and at the same time slide the cover in
the direction indicated by arrow (3). So the bulb can be
replaced. (Bulb type: 230-240 V, 15 W, E 14 thread)
After changing the bulb replace the cover, snap it in
place, screw back the screw and apply voltage to the
appliance