Filter
Top Products
1
2
7
Carefully lift (step 1)
and remove (step 2) the
glass panel.
Clean the glass panel with water and soap. Dry the glass
panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite se-
quence.
The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly. Refer to the illustration.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Remedy
The appliance does not operate. The appliance is not activated. Activate the appliance. Refer to the
chapter "Daily Use".
The appliance does not operate. The fuse in the fuse box is released. Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician.
The oven lamp does not operate. The oven lamp is defective. Replace the oven lamp.
Steam and condensation collect on
the food and in the oven.
You left the dish in the oven for too
long.
Do not keep the dishes in the oven
for longer than 15-20 minutes after
the cooking ends.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
11
www.zanussi.com