Zanussi ZOB 550 Oven User Manual


 
25
Telescopic Shelf Supports and
Catalytic Panels
The shelf supports and the catalytic panels can
be removed for easy cleaning.
Make sure the appliance is
completely cooled before carrying out
this operation.
The side rails with telescopic pull-out runners can be
completely removed for cleaning.
Proceed as follows:
1) remove the front screw while keeping the shelf
support and the catalytic panel in position with
the other hand (see diagram 1);
2) keep the shelf support and the catalytic panel
in position and lift them with a hand while
disengaging the rear hook. Take off the shelf
support and the catalytic panel (see diagram
2);
Clean the telescopic shelf supports on the
outside only with commercially available
detergents.
Important: The telescopic shelf supports must
not be cleaned in the dishwasher.
Attention: the rollers must not be greased.
3) once the cleaning is carried out, fit the shelf
support and the catalytic panel together and
mount them following the procedure in reverse.
Please, ensure the retaining nuts are secure when
refitting the shelf support and the catalytic panel.
It is possible to remove the telescopic runners
only, unlocking the elements as shown on
page 16.
The telescopic runners must not be cleaned
in the dishwasher.
1
2
)
Do not attempt to remove the
telescopic runners until the oven has
cooled down.
Do not competely pull out the
telescopic runners to remove them
from the side rails.
Sharp edges could cause injuries.