Filter
Top Products
Cleaning and maintenance
Cleaning should be carried out when the
appliance is COOL AND SWITCHED OFF AT
THE MAINS SUPPLY. Always clean off spillage
as quickly as possible to prevent burning on
which will make removal more difficult. Wash
with a clean cloth soaked in hot soapy water,
rinse and dry with a soft cloth. Do not use
abrasives, caustic pastes or sprays, coarse
cleaning pads or powders. Do not use excessive
water when cleaning your oven in order to avoid
water passing through clefts into the back of
controls panel or of the unit.
Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass
they can scratch the glass surface , which may
result in shattering of the glass.
Do not use steam cleaners to clean the oven.
The oven accessories (shelve, grid, oven shelf
carriers) and the oven door also, can be removed
for easier washing, to be done with a mild
detergent solution. The slots in the front of the
appliance for the passage of the air must
carefully kept unobstructed for an efficient cooling
of the unit.
Oven door removal and refitting
Open fully the oven door and hook the ring A to
the upper bar of the door hinge as shown in the
fig. 6. Once hinge locked, grip both sides of the
door, near the hinges, then lift and remove as
in the fig. 7. After cleaning refit the oven door
inversely proceeding in a similar way. Make
sure the lower bars of the hinges correctely
placed in the proper slots and the rings A
released from the upper bars before closing the
door.
Oven bulb replacement
Switch off your oven and isolate the power.
When the oven is cool, reach the light glass
cover and unscrew it as shown in fig. 8. Replace
the bulb with a new one with the same
specifications and screw the cover back until is
hand tight. Bulb replacement is not covered by
your Guarantee.
A
Fig. 6
Fig. 7
Fig. 8
8