Zanussi ZOU 461 Oven User Manual


 
25
Double circuit cooking zone
(Check the combination hob list in the "Technical
Data" chapter)
If you wish to have the two electric circuits work
simultaneously, turn the knob to maximum position 9
and then turn it towards symbol “
”. You will hear
a click. Now the 2 circuits work together.
Then, you can regulate the power of the cooking zone
by turning the control knob anticlockwise.
Carefully supervise cookings with oil or fats,
since these types of food can result in a fire,
when over-heated.
Safety Thermostat
To prevent dangerous overheating (through incorrect
use of the appliance or defective components), the oven is
fitted with a safety thermostat, which interrupts the power
supply. The oven switches back on again automatically,
when the temperature drops.
Should the safety thermostat trigger due to incorrect use
of the appliance, it is enough to remedy the error after the
oven has cooled down; if on the other hand, the thermostat
triggers because of a defective component, please contact
Customer Service.
The Cooling Fan
The cooling fan is designed to cool the the oven and
the control panel. The fan switches on automatically after a
few minutes of cooking. Warm air is blown out through the
aperture near the oven door handle. When the oven is
switched off, the fan may run on after the oven is switched
off to keep the controls cool. This is quite normal.
The action of the cooling fan will depend on how
long the oven has been used and at what
temperature. It may not switch in at all at lower
temperature settings nor run on where the oven has
only been used for a short time.
Before using the oven for the first time
Remove all packaging, both inside and outside
the oven, before using the oven.
Before using for the first time, the oven should be
heated up without food.
During this time, an unpleasant odour may be emitted.
This is absolutely normal. It is caused by manufacturing
residues.
Ensure the room is well ventilated.
1. Switch the oven function control knob to fan
cooking
.
2. Set the thermostat control knob to 250.
3. Open a window for ventilation.
4. Allow the oven to run empty for approximately
45 minutes.
)