Filter
Top Products
Programme Programme duration
(in minutes)
1)
Energy consumption
(in kWh)
Water consumption
(in litres)
- 0,4 6,0
1) The digital display shows the programme duration.
The pressure and temperature of the water, the variations of power supply and the quantity
of dishes can change these values.
Use of the appliance
Refer to the following instructions for each step
of procedure:
1. Make a check if the water softener level is
correct for the water hardness in your area. If
necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dishwasher.
5. Set the correct washing programme for the
type of load and soil.
6. Fill the detergent dispenser with the correct
quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
Setting the water softener
The water softener removes minerals and salts
from the water supply. Minerals and salts can
have bad effect on the operation of the appli-
ance.
Water hardness is measured in equivalent scales:
•German degrees (dH°).
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
for the hardness of water).
•Clarke.
Adjust the water softener in to the water hard-
ness in your area. If necessary, contact your local
water authority.
Water hardness
Water hardness
setting
Digital display
level
°dH mmol/l °TH Clarke
>24 >4.2 >40 > 28 5
18- 24 3.2- 4.2 32- 40 22- 28 4
12- 18 2.1- 3.2 19- 32 13- 22 3
4- 12 0.7- 2.1 7- 19 5 -13 2
< 4 < 0.7 < 7 < 5
1
1)
1) No use of salt required.
Electronic adjustment
The water softener is set at the factory at
level 3.
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
6