128 CHAPTER 6: IP SERVICES COMMANDS
Examples — To display SNMP settings on a WX switch, type the
following command:
WX1200# display snmp configuration
Snmp agent is enabled
System Name: WX1200
System location:
System contact:
Trap Name Enabled
---------------------------------- -------
LinkDownTraps YES
LinkUpTraps YES
AuthenTraps YES
DeviceFailTraps YES
DeviceOkayTraps YES
PoEFailTraps YES
MAPTimeoutTraps YES
MAPBootTraps YES
MobilityDomainJoinTraps YES
MobilityDomainTimeoutTraps YES
MichaelMICFailureTraps YES
RFDetectRogueAPTraps YES
RFDetectAdhocUserTraps YES
RFDetectRogueDisappearTraps YES
ClientAuthenticationFailureTraps YES
ClientAuthorizationFailureTraps YES
ClientAssociationFailureTraps YES
ClientAuthorizationSuccessTraps YES
ClientDeAssociationTraps YES
ClientRoamingTraps YES
AutoTuneRadioPowerChangeTraps YES
AutoTuneRadioChannelChangeTraps YES
CounterMeasureStartTraps YES
CounterMeasureStopTraps YES
ClientDot1xFailureTraps YES
Community Access Community Name
---------------- --------------
read-only public
read-write private
Table 34 describes the fields in this display.
