348 CHAPTER 11: IGMP SNOOPING COMMANDS
See Also
■ “display igmp mrouter” on page 348
■ “display igmp querier” on page 349
■ “display igmp receiver-table” on page 351
■ “display igmp statistics” on page 352
display igmp
mrouter
Displays the multicast routers in a WX’s subnet, on one VLAN or all
VLANs. Routers are listed separately for each VLAN, according to the port
number through which the wireless LAN switch can reach the router.
Syntax —
display igmp mrouter [vlan vlan-id]
■ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS displays the multicast routers in all VLANs.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — The following command displays the multicast routers in
VLAN orange:
WX1200# display igmp mrouter vlan orange
Multicast routers for vlan orange
Port Mrouter-IPaddr Mrouter-MAC Type TTL
---- --------------- ----------------- ----- -----
1 192.28.7.5 00:01:02:03:04:05 dvmrp 33
Table 66 describes the fields in this display.
VLAN VLAN name. MSS displays information separately for each
VLAN.
IGMP is enabled
(disabled)
IGMP state.
Table 65 Output for display igmp (continued)
Field Description
