A SERVICE OF

logo

Accessing the Host
9-5
Depending on your access privileges, you can use the regular set of
Business Modem AT commands.
CAUTION:
Be careful not to send
ATZ
or
ATZ!
or you will lose the
connection!
Remote
Configuration
Commands
There are special commands that can be used only during a
remote-access session.
You can change the host Business Modem’s serial port rate by using the
AT%B
n
command.
Example:
Sending
AT%B6
will change the Business Modem’s serial port
rate to 9600 bps.
If you have this access privilege You can use
View-only Any of the inquiry (ATI) commands
View and Configure Any of the Business Modem commands,
except those that cannot be used while
online (for example, ATD or ATA). You can
also use remote configuration commands.
See the next section for examples.
To change the host
Business Modem’s
serial port rate to
Command
To change the host
Business Modem’s
serial port rate to
Command
110 bps
AT%B0
9600 bps
AT%B6
300 bps
AT%B1
19200 bps
AT%B7
600 bps
AT%B2
38400 bps
AT%B8
1200 bps
AT%B3
57600 bps
AT%B9
2400 bps
AT%B4
115200 bps
AT%B10
4800 bps
AT%B5