A SERVICE OF

logo

Configuring PNNI Nodes
349
Set Default Node ID
Updates the ID of the PNNI node to the default address. A change to the
default node ID takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 3 4 2
The following message is displayed:
PNNI Node 1 of 1. Node ID was set to DEFAULT:
48.A0.47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.
F6.FF
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(4) NID: Node ID
(2) SDF: Set Default Node ID
Direct access sequence:
1 1 9 4 3 3 4 2
System action taken:
The current PNNI node id is set to the default address.
System message display:
PNNI Node 1 of 1. Node ID was set to
DEFAULT: <address>