10
ADDING transmitters using the learn button
• Press and hold down the transmitter button you wish
to program to the opener.
• The orange LED will flash continuously to indicate it is
receiving signal from the transmitter.
• Press and release the learn button on the opener.
• The courtesy LED will flash once.
• Ensure the door is clear of obstruction, then test the
transmitter.
DELETING ALL transmitter codes
NOTE: This deletes all learned transmitters.
• Press and hold the learn button until the
orange indicator light goes out (approximately 9
sec).
1
7
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No
one should enter or leave garage whilst door is in motion. Do not allow children to operate push
button(s) or transmitter(s). Do not allow children to play near the door.
Fix any wall control at a height of at least 1.5m and within sight of the door but away from any
m
oving parts.
NOTE: Your transmitter(s) have already been programmed into your opener.
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
