30
Performance characteristics
Inline skating with the Stroller is not permitted.
Assembly
To attach the stroller wheel, press the plastic button on the
side of the VersaWing 2.0 until it can go no further. Then, from
below, insert the upward pointing caster shaft of the stroller
wheel into the vertical hole of the VersaWing 2.0 until it can go
no further.
Release the plastic button. This now clicks back towards the
outside, resulting in locking of the attachment axle of the stroller
wheel.
DANGER
Always make sure that the stroller wheels are properly and
fully engaged and locked. To check this pull the stroller
wheels up and down in a vertical direction. Make sure that
the plastic locking button has fully clicked back. Incorrect
assembly may lead to accidents.
If you want to convert the carrier from Stroller to another CTS
Conversion Kit, you can store the stroller wheels on the top of
the VersaWing 2.0 .
To attach them proceed as described above.
The caster fork arms should point forwards.
DANGER
Always make sure that the stroller wheels are fully engaged
and locked.
Travelling
DANGER
So as to prevent it from tipping backwards, the storage
compartment at the rear of the carrier may not be loaded
with excessive weight. Carry out the following check: push
downwards on the handlebar by about 150 mm. The carrier
should return to its original standing position and should not
tip backwards.
Weight distribution
