34
Assembly
Attaching the skis to the carrier
Remove the wheels (for this, press the rubber cap in the centre
of the wheel).
To attach the skis, press the spring button in and insert the
attachment axle into the axle socket until it can go no further.
Release the spring button. By moving the skis from side to side,
check that they are locked in the axle socket and cannot be
pulled off.
DANGER
Always make sure that the ski tips point towards the front.
DANGER
Before each journey make sure that the skis are securely
locked in the axle socket.
Fitting the ski arms to the carrier
Insert each arm into the VersaWing 2.0 until the vertical holes
in the arms and VersaWing 2.0 are aligned with each other. The
arms should now, at the back in the slot of the VersaWing 2.0,
protrude about 2 cm / 3/4“ over the plastic edge.
DANGER
Always make sure that the security pins of the ski arms are
properly inserted to prevent the carrier from accidentally
sliding away. You run the risk of an accident!
TIP
The holes in the ski arms are larger than the security pins,
so that the arms can rotate slightly around their longitudinal
axes (in order to adapt to narrow or wide hips, and single and
double width carriers).
Now secure the arms by inserting the security pin from above
through the vertical hole in the arm and VersaWing 2.0 until it
stops. Lock the security pin by looping the spring clip over the
pins end that protrudes underneath the VersaWing 2.0.
