20
4. Extract the tank from the appliance and ll with water.
5. Insert the lter in the water tank and immerse it comple-
tely for about ten minutes, sloping it and pressing it lightly
to enable the air bubbles to escape (g. 46).
6. Insert the lter in the lter housing (g. 47A) and press as
far as it will go.
7. Close the tank with the lid (g. 47B), then put the tank
back in the machine.
When you install the lter, you must notify the appliance of its
presence.
8. Press the MENU/ESC button to enter the menu;
9. Press < or > (g. 9) until “Install lter” is displayed;
10. Press the OK button;
11. “Install?” is displayed;
12. Press the OK button to conrm the selection. “Water deli-
very Press OK “ is displayed;
13. Position a container under the hot water spout (min. capa-
city: 500 ml).
14. Press the OK button to conrm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
15. After delivery, the appliance is automatically ready to make the
next drink.
The new lter is active. You can now use the appliance.
Replacing the lter
When “REPLACE FILTER” is displayed, after two months (see date
indicator) or when the appliance has not been used for 3 weeks,
you should replace the lter:
1. Extract the tank and exhausted lter;
2. Take the new lter out of its packet and proceed as illustra-
ted in points 2-3-4-5-6-7 in the previous section;
3. Position a container with a minimum capacity of 500 ml
under the hot water spout;
4. Press the MENU/ESC button to enter the menu;
5. Press < or > until “Replace lter” is displayed;
6. Press the OK button;
7. “Conrm?” is displayed;
8. Press the OK button to conrm the selection;
9. “ Water delivery Press OK” is displayed;
10. Press the OK button to conrm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed;
11. After delivery, the appliance is automatically ready to make
the next drink.
The new lter is now active and you can use the coee machine.
Removing the lter
If you want to use the appliance without the lter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Extract the tank and exhausted lter;
2. Press the MENU/ESC button to enter the menu;
3. Press < or > (g. 9) until “Install lter, Enabled” is
displayed;
4. Press the OK button;
5. “Disable?” is displayed;
6. Press the OK button to conrm and the MENU/ESC button
to exit the menu.
TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 15 bar
Max. water tank capacity: 2 l
Size LxHxD: 260 x 360 x 460 mm
Cable length: 1.75 m
Weight: 11 kg
Coee beans container capacity: 400 g
The appliance complies with the following EC
directives:
• Low Voltage Directive 2006/95/EC and subsequent amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• European Stand-by Regulation 1275/2008;
• Materials and accessories coming into contact with food conform
to EC regulation 1935/2004.
