A SERVICE OF

logo

Chapter 2 Installation and Wiring|
2-12 Revision May 2008, ME14, SW V3.04
General
ξ‚„
Keep control wiring as far away as possible from the power wiring and in separate conduits to
avoid interference. If necessary let them cross only at 90ΒΊ angle.
ξ‚„
The AC motor drive control wiring should be properly installed and not touch any live power
wiring or terminals.
NOTE
ξ‚„
If a filter is required for reducing EMI (Electro Magnetic Interference), install it as close as
possible to AC drive. EMI can also be reduced by lowering the Carrier Frequency.
DANGER!
Damaged insulation of wiring may cause personal injury or damage to circuits/equipment if it comes
in contact with high voltage.