ASSEMBLY
OM 0370SB1388-A 15
7. Figure 8: Raise the chute slightly (item 1),
about 1/4" and wind the rotation bushing
(item 3) between the welded retaining plate
(item 2) and the chute ring (item 4) by
inserting it as illustrated. Fold back the
rotation bushing around the chute
8. Figure 9: Install the retaining plate (item 1)
on the snowblower by bending each
bushing end inside the retaining plate. Align
the vertical holes of the retaining plate with
the oblong holes (fig.7a) and fix with the
two 5/8" x 1 1/2" bolts (item 2) and 5/8"
serrated flange nuts. Do not tighten.
9. Figure 9: Insert two 1/2" x 3 1/4" bolts
(item 3) to join together the two retaining
plates. Hit the two bolt heads slightly with a
hammer in alternation to bring the two
retaining plates closer together. If the
retaining plate moves back after hitting it,
screw in the 5/8" x 1 1/2" bolts (item 2)
slightly. When the bolt ends (item 3) exceed
the holes enough, secure with two 1/2"
nylon insert lock nut until the two retaining
plates are approximately 1/4" apart.
10. Figure 9: Tighten the 1/2" x 3 1/4" bolts
(item 3) to reduce the gap between the
retaining plates until chute turns with a
slight resistance.
11. Figure 9: Slightly tighten the two 5/8" x
1 1/2" bolts (item 2).
12. Figure 10: Insert the anchoring flat bar
(item 1) between the anchoring plate
(item 3) and the motor support (item 2) as
shown. Screw the 3/8" nuts (item 4) all the
way to the top of the two 3/8" NC x 1 1/2"
bolts (item 5) and screw the bolt
assemblies into the anchoring flat bar
(item 1).
13. Figure 10 : Attach the motor (item 6) to the
motor support (item 3) with four 3/8" NC x
1 1/4" bolts, four 1/4" lockwashers and four
1/4" flat washers (items 7-8-9).
14. Figure 10: Install the gear (item 10) on the
motor shaft (item 6) making sure the key is
inserted in the shaft. Secure with a M8 x
1.25 x 25 mm bolt, a 5/16" lockwasher and
a 5/16" flat washer (item 11-12-13).
Figure 10
Figure 9
