Install the Advanced Web Interface (AWI) Module
313386D 13
Connect Module to EasyKey and
PC
1. Shut off ProMix 2KS/3KS power (0 position). FIG.
23. Also shut off power at main circuit breaker.
2. Run a CAT5 cable from the EasyKey connector
through the grommet and connect it to any port in
the AWI module. Connect another CAT5 cable from
the AWI module to the PC. See F
IG. 24.
3. Plug in the module power cord.
NOTE: Multiple AWI server hubs can be connected to
the AWI master module in series. See F
IG. 25. Order
Part No. 15V336 Hub, see page 39.
NOTICE
To avoid damaging circuit board when servicing, wear
grounding strap on wrist and ground appropriately.
F
IG. 23: Power Off
0 = OFF
TI12657a
FIG. 24: EasyKey and Module Cable Connection Points
TI12926a
TI12638a
CAT5 Cable Connector CAT5 Cable Grommets
EasyKey (Bottom View) Advanced Web Interface Module
Connect CAT5 Cables to any ports on module
