Wetting System
10 313384B
Wetting System
1. Fill hopper (G) with prepared textured material.
2. Install tip (see Nozzle Selection Chart, page 13).
3. Open gun air valve (23) to relieve air pressure.
4. Inspect hose for kinks which could restrict fluid flow.
5. Trigger gun into a pail. When texture material
appears at tip, move gun to hopper and circulate
until material flows in a solid stream. See System
Adjustment (page 14) for proper spray pattern and
pump and gun adjustments.
6. Adjust gun air pressure (U) and pump air pressure
(T) on sprayer to achieve desired result.
NOTICE
Do not mix material in hopper. Mixing material in hopper
can damage hopper, result in an inconsistent mix and
packout can occur.
NOTICE
Do not allow material to flow out of gun when air valve
(23) is closed or material packout in needle can occur.
ti3905a
G
TIξξξξ
23
NOTE: If spraying a simulated acoustic and course
aggregate material, disconnect hose at gun, prime
pump and hose and circulate material back into
hopper for 10 seconds. Turn off pump. Install gun
and tip.
WASTE
ti4290a
U
T
