-12-
G0572 Hanging Air Filter with Remote
Site planning is an important step to maximize the
effectiveness of the hanging air filter. Air circulation
must be thought out and all obstructions to the air
path considered.
Think of air circulation in terms of the circular
motion of the air before and after the air filter. The
air exiting the filter is exhausted at a higher veloc
-
ity than that entering it. Consequently, exhaust
being vented inside a building can have an effect
on the pattern of air circulation.
Air circulation patterns will vary depending upon
which method is used and according to your spe
-
cific shop setup. Figure 4 shows an example of
good air circulation
.
Site Planning
Figure 4. Good air circulation. The air filter
placement promotes circular air motion.
Filter
Machine Mobility
The Model G0572 has a balanced fan and uses
digital components that are sensitive to jarring.
Move this air filter unit with care, and do not drop
or handle it roughly.
Operating Location
Operating this air filter unit in the incorrect envi-
ronment can cause an explosion or respiratory
damage to you and others. Read safety instruc
-
tions on Page
6 to verify that the filter capabilities
will work in your environment.
Locate the air filter unit where the signal path for
the remote control is unobstructed and is used
within 75 feet of the control panel. Often, the
optimum location for this air filter unit is at an
overhead central shop location and not at the
corners.
Working Clearances
Consider your current and future shop needs
with respect to the machinery and the dust col
-
lection system used. Make sure that the inlet and
the outlet have at least 12" of clearance between
obstructions as not to restrict the air flow. The air
filter inlet should be a minimum of 3' from outside
air sources, such as windows, vents, and doors. If
the filter is too close to an outside air source, it will
filter the outside air instead of the shop air.
Outlets
Make sure the electrical circuits have the capacity
to handle the amperage requirements of the new
air filter unit. Refer to Page
7 for more informa-
tion. Electrical outlets should be located near
the unit so power or extension cords are clear of
high-traffic areas.
Shop Preparation
