A SERVICE OF

logo

Open as PDF
next previous
11
Assembly
• Separate the exhaust set pieces. Note the R (right side)
and L (left side) markings on the inside of each piece.
• Fit the inner half of the right exhaust pipe (R) over the
stabilizer wheel on the right side of the vehicle. Make
sure the peg on the inner exhaust pipe fits into the
hole in the vehicle body.
TM
6
TM
8
Vehicle Frame
(Right Side)
Stabilizer
Wheel
Vehicle
Body Hole
Right Exhaust
Pipe - Outer Half
• Fit the outer half of the right exhaust pipe (R) to the
inner half of the right exhaust pipe.
Right Exhaust
Pipe - Inner Half
Peg
Helpful Hint: Use a long-shafted screwdriver to complete
assembly steps 7 and 8.
• Align the holes in the inner half of the right exhaust pipe
with the holes in the vehicle frame.
• Insert four screws through the inner half of the right
exhaust pipe and into the vehicle frame.
Note: The screw marked with an asterisk (*) in the
illustration above must go through the hole in the inner
half of the right exhaust pipe, the vehicle body and into
the vehicle frame. Make sure all the holes are properly
aligned and the screw goes through all three parts.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
TM
7
Vehicle
Frame
Right Exhaust
Pipe - Inner Half
5
*
T
M
• The right footboard was inserted in the vehicle frame at
the factory. Make sure the right footboard is in place.
• Insert two screws into the right footboard as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Right
Footboard
Vehicle
Frame